:	Jul 14, 2004

.

Disconnect the battery ground cable.

.

: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands. Raise and support the vehicle.

.

Remove the engine undershield.

.

Release the fuel cooler.   Remove the retaining bolt.

.

Reposition the fuel cooler and the fuel filter housing.   Remove the two retaining bolts.

.

Remove the wiring harness retaining bolt.

.

Remove the starter motor retaining bracket.   Remove the four retaining bolts.

.

Reposition the starter motor.   Remove the two retaining bolts.

.

Remove the starter motor.   Reposition the rubber insulator.   Remove the two starter motor harness retaining nuts.

.

Install the starter motor.   Tighten the battery positive terminal integral connector retaining nut to 11 Nm (8 lb.ft).   Tighten the solenoid terminal integral connector nut to 7 Nm (5 lb.ft).   Reposition the rubber insulator.

.

Reposition the starter motor.   Install the two retaining bolts.   Tighten the bolts to 48 Nm (35 lb.ft).

.

Install the wiring harness retaining bolt.   Tighten the bolt to 10 Nm (7 lb.ft).

.

: The starter motor retaining bracket must be installed. Failure to follow this instruction may result in damage to the vehicle. Install the starter motor retaining bracket.   Install the 4 bolts and tighten to 10 Nm (7 lb.ft).

.

Reposition the fuel cooler and the fuel filter housing.   Install the two bolts and tighten to 10 Nm (7 lb.ft).

.

Attach the fuel cooler.   Install the bolt and tighten to 10 Nm (7 lb.ft).

.

Install the engine undershield.

.

Connect the battery ground cable.